Miaustore Pump usage and maintenance
With continuous usage of the pump sometimes dirt, cat hair, food particles can get
accumulated inside the pump and lower its efficiency. This may permanently damage
the pump. It is very important that when we change the water and clean the ceramic
parts, we must also clean the pump.
Please note that the pump must be switched on only when it is fully submerged in water. Operating the pump without water will burn the coils and damage the pump.
Step 1 : Disconnect the pump and remove it from fountain
Step 2: Remove back cover using a star screwdriver
Step 3: Pull out the pump’s propeller
Step 4: Soak the pump and the dismantled parts in warm water or water with dishwashing soap or vinegar for 30 minutes.
Step 5: Use brush to clean all parts and specially the rotor and inner body of pumps. You can use a toothpick or a very small bottle brush to make sure there is no dirt stuck in the cavities of the pump.
Step 6: Rinse the pump under running water
Step 7: After cleaning you can put the propeller back into the pump and put the screws back.
Step 8: Assemble pump with the plastic parts and setup the fountain.
Use a stick, toothpick or a bottle brush to clean out all the cavities and passages for water.